High-tech targets and gun accessories
Some ingenious solutions for firearms training
Firearms and use of force topics have always been popular subject matter at conferences of the International Law Enforcement Educators and Trainers Association (ILEETA), and the 2012 conference was no exception. The conference includes a trade show/expo of training products and services, also with a big emphasis on firearms, and I saw a few products that were ingenious, useful, and perhaps most importantly, low-cost.
I usually confine my columns to things that blink, buzz, and require electrical power, but I also like to think of myself as one of the sheepdogs who knows when and how to use a gun, can carry one lawfully, and usually does.
Thus, innovations in this market interest me as much as the techie stuff you usually see discussed here.
One of their products is a cardboard box-like frame that supports conventional clothing on the outside and a balloon on the inside. You construct the “box” from some flat-folding components and dress it (with discarded thrift-store clothing) to produce a 3-D human-size target.
The inflated balloon goes on the inside of the box, and attaches to an overhead support wire with a binder clip. When the shooter hits the target’s virtual X-ring, the balloon pops and the target assembly falls to the ground. A reset requires only a fresh balloon, although obviously the cardboard frame will have to be replaced now and then.
The 3-D targets are enhanced with life-size card stock overlays of facial and upper-body photographs of various models (sorry, no political figures or law enforcement administrators), which are attached with spray adhesive to the underlying target frame. The card stock paper that Targets Online uses is specially treated to resist moisture. A display at their booth had a steady stream of water running over a paper target, with virtually no degradation of the material.
The photographic paper overlays employ another innovation — an overlay for the overlay. With conventional photographic image targets, there are a finite number of images available, and an observant shooter can quickly learn that the guy in the gray sweatshirt is going to have a gun, while the women in the blue blouse is holding a cell phone.
The Targets Online solution to this problem is a small overlay, matched to the underlying image, of a hand holding a gun, a knife, a badge, a cell phone, a water bottle, etc. Their catalog has six variations for each of four life-size targets, so it’s not necessary to buy a whole large target for each threat/non-threat type. You just change the “weapon” by applying a new overlay. This is an innovative and inexpensive way to add more variation and realism to firearms training.
Moving and pop-up targets are nothing new, but they are traditionally expensive and require an electrical connection between the target and the rangemaster to cue the movement. Challenge Targets achieves motion via an unpowered mechanism run via counterbalances and springs. When a target is knocked down by a hit, it resets itself automatically after a brief delay.
Lateral movement is achieved with simple pull cords that can be operated from a safe position. The targets are less expensive than electrically-operated pop-up or lateral movement targets, and less prone to failure because of their simple design.
Train Safe is a plastic rod, roughly the size of a popsicle stick, that inserts into the barrel of a variety of handguns. Once there, it advertises its presence with the end visible at the muzzle, but not protruding. The gun can be holstered or stored as usual. The rod extends to the rear of the barrel, making it impossible to chamber a round.
The handler can still work the action and operate the trigger mechanism, but the gun is disabled from firing until the rod is removed. The rod inserts and is removed by field-stripping the slide and barrel. The firearm blocks retail for $5.00, and are custom-sized for most popular handguns.
|Back to previous page|